To load film, first pull up the Rewind Knob to open the camera
back. Drop the film cartridge in place, then push the Rewind Knob
back down, turning if necessary to seat it. Lay the film across the
camera back until the tip reaches the red mark. Holding the film in
place, close the back.
2.
You will notice the Exposure Counter is on "S". Wind the film
with the Film Advance Lever and press the Shutter Release until the
counter reads "0". You are now ready to wind the film for the first
picture. You can wind the film with a full stroke or with several
small strokes.
3.
Since films have different sensitivities, you must set the camera
for the film you are using. Lift the ring around the Shutter Speed
Dial and turn it until your film's ASA speed is opposite the "1.8"
index (when using the normal lens) or the "3.5" index (when using
an accessory lens). (See page 11.)
Software and eBooks for your Palm-powered PDA.
