Projeto de :
www.aaroncake.net
This simple tone control can be used in may audio applications. It can be
added to amplifers, used as a stand alone control module, or even built into new
and exciting instruments. It's one IC construction makes it a very compact
circuit, as only a few support components are required. Plus, it does not use a
dual power supply. This means that the circuit will run from 9V to 15V (although
the bass will be a little weak at 9V). The circuit is by Robert Barg and
originally appeared in the Think Tank column of the May 1998 issue of Popular Electronics..
1. S1 is a contour control. Volume is controlled by R11. Balance is
controlled by R10. R9 and R8 control bass and treble, respectivly.
2. J1 is the left input, J4 is the right input. J2 is the left output, J3 is
the right output.
3. The circuit is designed to accept line level or mic level inputs. if you
are going to be using a stronger signal, a voltage divider will be necessary to
cut it down to proper levels.
4. You can, of course, skip J1-J4 if you plan to integrate this circuit into
another.
C1, C3, C5, C7, C15, C16
6
2.2uf Electrolytic Capacitor
C2, C6
2
0.05uF Ceramic Disc Capacitor
C4
1
0.22uF Disc Capacitor
C8, C10
2
0.015uF Ceramic Disc Capacitor
C9
1
100uF Electrolytic Capacitor
C11, C12, C13, C14
4
0.1uF Ceramic Disc Capacitor
R1, R4
2
10K 1/4W Resistor
R2, R5
2
33K 1/4W Resistor
R3, R6
2
4.7K 1/4W Resistor
R7
1
2.2K 1/4W Resistor
R8, R9, R10, R11
4
50K Linear Pot
U1
1
TDA1524A Tone Control IC
S1
1
SPST Switch
J1, J2, J3, J4
4
RCA Jacks
MISC
1
Board, Wire, Knobs, 18 Pin Socket
Notes:
© J.Sabino 2003 - 2005