AUTOMATIC ROBOT SENTRY
to activate.
1. hold left sensor
2. turn on robosapien
3. within 5 seconds press right sensor 4 times.
*. robosapien will say HEY to indicate hes now in diagnostic mode.
once activated.
1. left sensor test, press left sensor 3 times.
2. right sensor test, press right sensor 3 times.
3. right arm extend test
4. left arm extend test
5. right arm up test
6. left arm up test
7. sonic sensor,. wait for sound. when sound head activate test 8
8. walk forward test.
9. infrared test. wait for infrared. when infrared recieved test 10.
10. speaker tone test 11.
reset ready for use.
Diagnostic mode 2
to activate.
1. hold left sensor
2. turn on robosapien
3. within 5 seconds press left sensor 4 times.
*. robosapien will say HEY and then whistle to indicate he's now in
diag. mode 2.
once activated.
1. press right sensor. will beep if sensor okay
2. extend right arm outwards manually, burp on half extend, wowee
on full extend (claw open) * leave arm up fully and extended
3. press left sensor. will beep if sensor okay
4. extend left arm outwards manually, yeah on half extend, fart on full
extend (claw open) * leave arm up fully and extended (claw open)
5. automatic right arm test
6. automatic left arm test
7. automatic lean right test
8. automatic lean left test
10. automatic lean forwards test
11. automatic lean backwards test
12. make loud noise, sonic test owha if okay
13. press remote key, infrared test owha if okay
14. press left sensor to complete test mode and return to ready for use
mode.
Automatic Robot Sentry
In ?Listen? mode, your Robosapien will wait for over 2 hours before
getting bored and shutting down. You can link in the listen modes up
to 14 times using the regular P program,;
the following is an example of how to make your robot ?guard? a h
allway for hours and always stay in place.
Press S> Select ? Select ? LeftTurn (Strike3 on the right controller side) Select ? Listen Select ? Select ? Stop (Roar)
Select ? Listen Select ? Select ? RightTurn (Strike3 on l-ctrl)
Select ? Backwards
STOP
Press P
Press S> 14 times or until the robot says ?Ooo! Uh-Huh!?
Robosapien will now enter a mode where he will wait against a wall and strike anything that passes by, occasionally stepping back into place against the wall.
He will do this 42 times before finally stopping.
Press STOP to deactivate.
Press P> to play again.
Change the S> reflex to the following for more in-your-face action.
Press S> Select ? Select ? Stop (Roar)
Select ? Forwards Select ? Forwards S
elect ? Select ? LeftTurn (Strike3 on the right controller side)
Select ? Select ? RightTurn (Strike3 on the left controller side)
Backwards
STOP P>
Robosapien will now awaken, come forward and attack, then
return to his place at the wall.